Quadra-Trac Ii Operating Instructions/Precautions - If Equipped - Jeep 2004 Grand Cherokee Owner's Manual

5 km/h). Avoid attempting to engage or disengage 4LO
with the vehicle moving faster than 2 to 3 mph (3 to 5
km/h).
Quadra-Trac II Operating
Instructions/Precautions — If Equipped
The Quadra-Trac II transfer case is fully automatic in the
normal driving 4 ALL TIME mode. The Quadra-Trac II
transfer case provides three mode positions — four wheel
drive high range, neutral, and four wheel drive low
range.
This transfer case is fully automatic in the 4 ALL TIME
mode. The 4 ALL TIME mode transmits torque to the rear
axle during normal driving, similar to a rear wheel drive
vehicle. When speed difference is increased between the
front and rear driveshafts the majority of engine torque
can be transmitted to the front driveshaft.
When additional traction is required, the 4LO position
can be used to lock the front and rear driveshafts together
STARTING AND OPERATING 191
and force the front and rear wheels to rotate at the same
speed. The 4LO position is intended for loose, slippery
road surfaces only. Driving in the 4LO position on dry
hard surfaced roads may cause increased tire wear and
damage to driveline components.
When operating your vehicle in 4LO, the engine speed is
approximately three times that of the 4 ALL TIME
position at a given road speed. Take care not to overspeed
the engine and do not exceed 25 mph (40 km/h).
Proper operation of four wheel drive vehicles depends on
tires of equal size, type, and circumference on each
wheel. Any difference will adversely affect shifting and
cause damage to the transfer case.
Because four wheel drive provides improved traction,
there is a tendency to exceed safe turning and stopping
speeds. Do not go faster than road conditions permit.
5