Rocking The Vehicle; Four-Wheel Drive Operation; Selec-Trac Operating Instructions/Precautions - Jeep 2004 Grand Cherokee Owner's Manual

186 STARTING AND OPERATING

Rocking the Vehicle

If the vehicle becomes stuck in snow, sand, or mud, it can
often be moved by a rocking motion. Move the gear
selector rhythmically between "First" and R (Reverse),
while applying slight pressure to the accelerator.
The least amount of accelerator pedal pressure to main-
tain the rocking motion without spinning the wheels or
racing the engine is most effective. Racing the engine or
spinning the wheels, due to the frustration of not freeing
the vehicle, may lead to transmission overheating and
failure. Allow the engine to idle with the transmission
selector in N (Neutral) for at least one minute after every
five rocking-motion cycles. This will minimize overheat-
ing and reduce the risk of transmission failure during
prolonged efforts to free a stuck vehicle.
CAUTION!
When "rocking" a stuck vehicle by moving between
"First" and R (Reverse), do not spin the wheels faster
than 15 mph (24 km/h), or drivetrain damage may
result.

FOUR-WHEEL DRIVE OPERATION

Selec-Trac Operating Instructions/Precautions

The Selec-Trac transfer case provides five mode posi-
tions — two (rear) wheel drive high mode, part-time four
wheel drive high range, full-time four wheel drive high
range, neutral, and four wheel drive low range.
This transfer case is equipped with an inter-axle differ-
ential which allows driving the vehicle in the 4 FULL
TIME position at all times on any given road surface
including dry hard surfaced roads. The 4 FULL TIME