Download Print this page
Sony RDP-X60iP Operating Instructions

Sony RDP-X60iP Operating Instructions

Personal audio docking system

Advertisement

Quick Links

Personal Audio
Docking System
Operating Instructions
RDP-X60iP
©2011 Sony Corporation
Printed in China
Owner's Record
The model number and the serial number are located on the
4-278-207-11(1)
bottom.
Record the serial number in the space provided below. Refer to
them whenever you call upon your Sony dealer regarding this
product.
Model No. RDP-X60iP
Serial No. ________________________________
For customers in the USA
Please register this product on line at
http://www.sony.com/productregistration
Proper registration will enable us to send you
periodic mailings about new products, services
and other important announcements. Registering
your product will also allow us to contact you in
the unlikely event that the product needs
adjustment or modification. Thank you.
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To reduce the risk of fire, do not cover the ventilation of
the apparatus with newspapers, tablecloths, curtains, etc.
And do not place lighted candles on the apparatus.
To reduce the risk of fire or electric shock, do not expose
this apparatus to dripping or splashing, and do not place
objects filled with liquids, such as vases, on the
apparatus.
Do not install the appliance in a confined space, such as
a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or batteries
installed) to excessive heat such as sunshine, fire or the
like for a long time.
As the main plug is used to disconnect the unit from the
mains, connect the unit to an easily accessible AC outlet.
Should you notice an abnormality in the unit, disconnect
the main plug from the AC outlet immediately.
The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even
if the unit itself has been turned off.
The nameplate and important information concerning
safety are located on the bottom exterior of the main unit
and on the surface of the AC power adaptor.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
This equipment must not be co-located or operated in
conjunction with any other antenna or transmitter.
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65 and
RSS-102 of the IC radio frequency (RF) Exposure rules.
This equipment has very low levels of RF energy that it
deemed to comply without maximum permissive
exposure evaluation (MPE). But it is desirable that it
should be installed and operated keeping the radiator at
least 20cm or more away from person's body (excluding
extremities: hands, wrists, feet and ankles).
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of the
device.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same type.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
WARNING
Replace the battery for the remote commander with a
Sony CR2025 lithium battery. Use of another battery
may present a risk of fire or explosion.
Battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
Dispose of used battery promptly. Keep away from
children.
Important Safety Instructions
1)
Read these instructions.
2)
Keep these instructions.
3)
Heed all warnings.
4)
Follow all instructions.
5)
Do not use this apparatus near water.
6)
Clean only with dry cloth.
7)
Do not block any ventilation openings.
Install in accordance with the manufacturer's instructions.
8)
Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9)
Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has
two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
Because Bluetooth devices and wireless LAN
particularly at plugs, convenience receptacles, and the
(IEEE802.11b/g/n) use the same frequency, microwave
point where they exit from the apparatus.
interference may occur and resulting in communication
11) Only use attachments/accessories specified by the
speed deterioration, noise, or invalid connection if this
manufacturer.
unit is used near a wireless LAN device. In such as case,
12) Use only with the cart, stand, tripod, bracket, or table
perform the following.
specified by the manufacturer, or sold with the apparatus.
– Use this unit at least 10 m (about 30 ft) away from
When a cart is used, use caution when moving the
any wireless LAN device.
cart/apparatus combination to avoid injury from tip-over.
– If this unit is used within 10 m (about 30 ft) of a
wireless LAN device, turn off the wireless LAN device.
– Install this unit and iPod as near to each other as
possible.
Microwaves emitting from a Bluetooth device may
13) Unplug this apparatus during lightning storms or when
affect the operation of electronic medical devices. Turn
unused for long periods of time.
off this unit and iPod in the following locations, as it
14) Refer all servicing to qualified service personnel. Servicing
may cause an accident.
is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
– where inflammable gas is present, in a hospital, train,
has been spilled or objects have fallen into the apparatus,
airplane, or a petrol station
the apparatus has been exposed to rain or moisture, does
– near automatic doors or a fire alarm
not operate normally, or has been dropped.
This unit supports security capabilities that comply
For the state of California USA only
with the Bluetooth standard to provide a secure
Perchlorate Material –special handling may apply, see
connection when the Bluetooth wireless technology is
www.dtsc.ca.gov/hazardouswaste/perchlorate
used, but security may be insufficient, depending on
the setting. Be careful when communicating using
Perchlorate Material: Lithium battery contains perchlorate
Bluetooth wireless technology.
The validity of the CE marking is restricted to only those
We do not take any responsibility for leakage of
countries where it is legally enforced, mainly in the
information during Bluetooth communication.
countries EEA (European Economic Area).
Connection with all Bluetooth devices cannot be
guaranteed.
– A device featuring Bluetooth function is required to
Disposal of Old Electrical & Electronic
conform to the Bluetooth standard specified by
Equipment (Applicable in the European
Bluetooth SIG, Inc. and be authenticated.
Union and other European countries
– Even if the connected device conforms to the above
with separate collection systems)
mentioned Bluetooth standard, some devices may
not be connected or work correctly, depending on
the features or specifications of the device.
On Copyrights and Licenses
Depending on the device to be connected, it may
The Bluetooth word mark and logos are owned by the
require some time to start communication.
Bluetooth SIG, Inc. and any use of such marks by Sony
Corporation is under license. Other trademarks and
Note
trade names are those of their respective owners.
In the Operating Instructions, "iPod" is used as a
general reference to functions on an iPod, iPhone or
iPhone
, iPod
, iPod classic
, iPod nano
, and iPod
iPad, unless otherwise specified by the text or
touch
are trademarks of Apple Inc., registered in the
illustrations.
U.S. and other countries.
"Made for iPod, " and "Made for iPhone" mean that an
If you have any questions or problems concerning your
electronic accessory has been designed to connect
unit, please consult your nearest Sony dealer.
specifically to iPod or iPhone, respectively, and has been
certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of
Power sources
this device or its compliance with safety and regulatory
standards. Please note that the use of this accessory with
iPod or iPhone may affect wireless performance.
Preparing a power source
Features
1
Connect the AC power cord (supplied) to the AC
power adaptor (supplied).
Wireless Music Streaming
2
Connect the AC power adaptor to the
Compatible with iPod and iPhone
jack on the back of this unit firmly and plug it into a
MEGA BASS
wall outlet.
Wireless remote commander supplied
Precautions
To disconnect the AC power cord (mains lead), pull it
out by the plug, not the cord.
Since a strong magnet is used for the speaker, keep
credit cards using magnetic coding or spring-wound
watches, CRT-based TVs, or projectors, etc., away from
the unit to prevent possible damage from the magnet.
Do not leave the unit in a location near a heat source such
as a radiator or airduct, or in a place subject to direct
sunlight, excessive dust, mechanical vibration, or shock.
Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on a surface (a rug, a
blanket, etc.) or near materials (a curtain) which might
block the ventilation holes.
Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by qualified
personnel before operating it any further.
Do not handle the unit with wet hands.
Note on the AC power adaptor
Do not place the unit anywhere near water.
Use the supplied Sony AC power adaptor only. The polarity of the
plugs of other manufactures may be different. Failure to use the
NOTES ON LITHIUM BATTERY
supplied AC power adaptor may cause the unit to malfunction.
Wipe the battery with a dry cloth to assure a good contact.
Be sure to observe the correct polarity when installing
the battery.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
On Bluetooth communication
Bluetooth wireless technology operates within a range
of about 10 meters (about 30 ft).
Maximum communication range may vary depending
on obstacles (human body, metal, wall, etc.) or
electromagnetic environment.
The unit
Steel cabinet
Optimal performance
Limited performance
The following conditions may affect the sensitivity of
Bluetooth communication.
– There is an obstacle such as a person, metal, or wall
between this unit and iPod.
– A device using 2.4 GHz frequency, such as a wireless
LAN device, cordless telephone, or microwave oven,
is in use near the unit.
– The unit is installed on a shelf made of steel.
Preparing the remote
commander
Before using the remote commander for the first time,
remove the insulation film.
When to replace the battery
With normal use, the battery (CR2025) should last for
about 6 months. When the remote commander no longer
operates the unit, replace the battery with a new one.
the  side facing up
Notes
Do not attempt to charge the battery.
If you are not going to use the remote commander for a long time,
remove the battery to avoid any damage that may be caused by
leakage and corrosion.
DC IN 20V
AUDIO IN
DC IN 20V
To wall outlet
AC power adaptor
AC power cord

Advertisement

loading

Summary of Contents for Sony RDP-X60iP

  • Page 1 AC power adaptor AC power cord Note on the AC power adaptor Use the supplied Sony AC power adaptor only. The polarity of the  plugs of other manufactures may be different. Failure to use the supplied AC power adaptor may cause the unit to malfunction.
  • Page 2 To use an iPod, refer to the user’s guide of your iPod. menu  Sony cannot accept responsibility in the event that data recorded on  Go back to the main menu Press and hold MENU* an iPod is lost or damaged when using an iPod connected to this unit.