Learning The Commands Of Other Remote Commanders - Sony RM-TP2 Operating Instructions Manual

Performing several commands in sequence
automatically (Macro Play) (continued)
Using the Auto Power function
In step 5, link the remote (component) to
"AUTO POWER". For the video components,
the following display appears. Select the wait
time and the input of the TV.
Notes
• The TV input may not switch automatically on all
Sony TVs. This is because some TVs cannot
receive remote control codes immediately after
being turned on. In this case, set the wait time.
• When you select "TV" as the video input, the TV
input does not switch.
To cancel MACRO LINK
Select "OFF" in the MACRO LINK screen.
GB
26
Select the wait time.
Select the input of the TV.
Learning the commands of
other remote commanders
Setting remote control codes
that are not stored in the
commander
When a remote control code is not one of the
presets stored in the commander, it is possible
for the commander to learn the code using the
Learning function.
Learning function can be used for each preset
operation keys and USER RESERVE KEYS.
To program an IR code to the preset
operation keys
1
Touch RM SELECT.
The RM SELECT screen appears.
2
Touch the remote (component) ("MD"
for example).
Or, turn the jog dial to select the remote
(component), then press the jog dial to enter
the selection. The screen for operating the
component appears.
3
Touch .
The pull-down menu appears.
4
Touch LEARN in the pull-down menu.
The commander enters the learning mode.
"LEARN" appears.