Sony RM-TP2 Operating Instructions Manual page 24

Performing several commands in sequence
automatically (Macro Play) (continued)
7
Select the maker ("Sony VTR1" for
example).
The COMMAND list appears.
8
Select the command ("POWER" for
example).
The items selected in steps 6 to 8 are
registered in the box selected in step 5.
The macro step number (BOX) list
reappears. You can program up to 24 steps.
To operate Sony components
When selecting the category in step 6, you can
select the operation such as turning on/off Sony
components or switching the input of Sony TVs.
To delay the output of an IR code
Select "WAIT TIME" from the CATEGORY
list. The wait time list ("1sec" to "60sec" (1 to
60 seconds)) appears. Select the time you want
to wait.
To use learned codes under the
Macro Play function
Select "RESERVE KEYS" from the
CATEGORY list. Then, select the button for
the learned IR code.
GB
24
To cancel programming
Touch EXIT or CANCEL during any step.
To clear the programmed IR code
Select the macro step number (BOX) you want
to clear the IR code, then select "MACRO
CLEAR" from the CATEGORY list.
To change the name of the Macro
Play
In step 4, touch MACRO NAME EDIT. Touch
the name input buttons to enter the name (up to
10 characters), then touch SET. Touch EXIT to
return to the MACRO screen.
Current name display
Name input display
Name input buttons
To start Macro Play
1
Touch MACRO.
The MACRO screen appears.
2
Turn the jog dial to select the Macro
Play, then press the jog dial to enter the
selection.
To cancel the Macro Play during operation,
press the jog dial again.
Note
If the Macro Play function does not work properly,
try setting a "WAIT TIME" between each command.