Table of Contents
Advertisement
2. Taking an Image
When the parameter changing screen appears automatically
When the parameter change screen in DISPLAYING PARAMETER CHANGE/QA
SCREEN DURING EXPOSURE (→ Setup Guide) is set to [VALID], the parameter
changing screen (figure below) will appear. Refer to 2.2.2 Changing Generator
Parameters after Exposure Mode Selection (→ page 18) and change the
parameters.
When print settings need to be changed
The printing method is registered in exposure mode, so when the printer parameters or
other settings have changed, a window will open and the message "Printer settings
have changed. Set the printer settings again." will appear. Touch [OK] to open the
print setting window (→ Setup Guide) and change the settings as required.
When a warning message concerning the grid appears
If the grid of the sensor unit is replaceable, it is possible to register whether to display
the grid warning message for each exposure mode when editing the mode (→ Setup
Guide).
If WARNING MESSAGE ON GRID has been set to [VALID] and the currently
installed grid differs from the recommended grid, a window will open (figure below)
and the recommended grid name (or YES/NO) will appear. Touch [OK] to replace
the grid with the recommended grid, or attach/detach the grid as required.
– 16 –
Advertisement
Table of Contents
