Mitsubishi Electric DD-4020 Service Manual page 2

Table of Contents

Advertisement

HOW TO INITIALIZE THE SETUP MENU
After turning the power ON, without a disc in the tray, press the "1," "2," "3," "4," "DISPLAY" and "ENTER" buttons
on the remote control unit in this order. Then, after turning the power OFF temporarily, turn the power ON again
to intialize the Setup Menu.
HOW TO CLEAR THE PASSWORD PROTECTION
(In case of forgetting the password of Parental Lock)
To release the parental lock, initialize the DVD player in the same way above.
HOW TO SET OR CLEAR THE TRAY LOCK
To set the tray lock mode to on, follow the procedures below:
1. With loading a disc, set the DVD player to the stop mode.
2. Press the "SETUP" button to display the SETUP menu.
3. Press the "TITLE" button.
4. Press the "3" button.
5. Press the "AUDIO" button.
6. Press the "0" button.
7. Press the SETUP" button. Tray Lock mode is set to ON and "Tray Lock On" is displayed on the top right of
the screen.
While the Tray Lock mode is on, the operation of opening or closing the tray is being canceled. Other operatins
are available.
To release the Tray Lock mode, perform the above procedures again. Tray Lock mode is set to OFF and "Tray
Lock Off" is displayed on the top right of the screen.
HOW TO MANUAL EJECT
1. Remove the Top Case.
2. Insert the eject-bar (length = approximately 3 mm,
diameter = approximately 8 mm) into the manual eject
hole on the PCB Holder. Then, press it until the tray
is ejected.
3. Pull out the tray.
Manufatured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby
Laboratories. Confidential Unpublished Works.
(©1992-1997 Dolby Laboratories, Inc. All rights reserved.)
"DTS" and "DTS Digital Out" are trademarks of Digital Theater Systems Inc.
Top Case
Tray
PCB Holder
Eject-Bar (Length = approximately 80 mm, Diameter = approximately 3 mm)
Manual
Eject Hole

Advertisement

Table of Contents
loading

Table of Contents