Information On The Measuring Point - Pepperl+Fuchs Barcon PPC Operating Instructions Manual

4.4

Information on the measuring point

The following information on the measuring point can be called up with the handheld
terminal:
Parameter field Display or entry
Measured values
V0H0 Main measured value for pressure
V7H0 Current display: Actual current in mA
V7H8 Sensor pressure (units in V0H9) selectable
V9H7 Actual dampened pressure without bias correction
Sensor data
V7H4 Lower calibration pressure
V7H5 Upper calibration pressure
V7H6 Lower measurement limit of sensor (units in V0H9 selectable)
V7H7 Upper measurement limit of sensor (units in V0H9 selectable)
Information on transmitter
V2H2 8010 = Software number
Sensor data No.: Number of entry in the sensor table (1...10).
V2H7
Please remove from sensor pass
Sensor data value: Entry in sensor table, contains all sensor-specific data. Please
V2H8
remove from sensor pass
Error response
V2H0 Actual diagnostic code
V2H1 Last diagnostic code
Parameter field Display or entry
Measuring point tag. The measuring point can be identified here with a max. of 8
VAH0
characters.
VAH1 Descriptor. A max. of 16 characters can be entered here for the Descriptor.
VAH2 User text. A max. of 8 characters can be entered here.
VAH3 Serial number of the transmitter
VAH4 Serial number of the sensor
Barcon LHC/PPC (HART)
Commissioning
Communication level
29