OttLite MG015INT3 Quick Start Manual

A
B
3.5-inch LED Magnifier with Clip and Stand
MG015INT3
INS140103
C
ENGLISH
CONGRATULATIONS!
You've purchased the finest in natural lighting
technology with your new OttLite product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product
Registration Form and return it today by mail,
or register online by going to:
http:/www.OttLite.com/warranty
NOTE: This item can be used with either stand
or clip as needed.
CAUTION! RISK OF FIRE! Never place
magnifier in direct sunlight.
Use with Base
Unpack all freestanding LED magnifier parts
1.
and lay out with the base lying flat.
Insert flexible arm of lighted magnifier into
2.
base, then insert screw (provided) into
magnifier base and secure to the flexible arm
of the magnifier with a Phillips screwdriver;
see diagram A.
Prior to LED light function, remove or "PULL"
3.
battery tab prior to use. NOTE: Tab is located
around the battery door location.
Use with Clip
Align screw attached to clip with bottom
1.
of flexible arm and twist clip to secure as
needed; see diagram B.
BATTERy INSTALLATION/REMOvAL
WARNING: Keep away from children. If
swallowed,promptly see doctor. Do not install
backwards, charge, put in fire or mix with other
battery types – may explode or leak causing
injury.
Locate battery compartment under head
1.
of magnifier.
Remove screw and pull lever slightly to
2.
remove battery cover.
Remove/replace batteries with required
3.
LR1130 batteries ONLy.
Attached battery cover when finished.
4.
NOTE: DO NOT over-tighten screws to avoid
them being striped; see diagram C.
This product uses four button cell batteries
5.
Notice: Only replace batteries as a
simultaneous set and do not mix with older
batteries. Remove batteries if consumed
or if the light has not been in use for a long
period of time.
YT80114BC REV030714