Transducer - Eagle Ultra Classic Installation And Operation Instructions Manual

To Ultra
Classic
POWER CONNECTIONS
RED
WIRE
BLACK 3 amp
WIRE
FUSE
TO SPEED/TEMP
SENSOR
(Not included with
12 VOLT
Ultra Classic.)
BATTERY
TRANSDUCER INSTALLATION
The HS-WSBK supplied with your Ultra Classic is a transom mount
transducer. It can be installed on any outboard or stern-drive
(inboard\outboard) powered boat. It can also be permanently installed
inside the boat to "shoot-through" the hull on some fiberglass boats.
The "kick-up" mounting bracket helps prevent damage if the transducer
strikes an object while the boat is moving. If the transducer does "kick-
up", the bracket can easily be pushed back in place without tools.
Read the enclosed transducer installation manual carefully before at-
tempting the installation. Determine which of the mounting positions is
right for your boat. Use extreme care if mounting the transducer inside
the hull, since once it is epoxied into position, the transducer usually
can't be removed without damaging it. Remember, the transducer loca-
tion is the most critical part of a sonar installation. If it isn't done
properly, the sonar can't perform to its designed potential.
5