To Activate Group Mode (Group Mode Recording); Recording A Track Into A New Group - Sony MZ-N1 Operating Instructions Manual

How is group information
recorded?
When recording in group mode, the group
information is written to the disc name
recording area.
This information consists of text strings
that are written as shown in the following
example.
Disc name recording area
Example
1
1 Disc name: "Favorites"
2
Group name for tracks 1 to 5: "Rock"
3
Group name for tracks 6 to 9: "Pops"
Therefore, the above character string is
displayed in its entirety as the disc name
if you load an MD recorded in group
mode into a system that does not support
group mode, or if you try to edit the
contents of a disc on this recorder with
group mode turned off.
It is possible to change the
character string by doing
"Relabeling recordings" procedure
in the "Labeling/relabeling
recordings" (page 39). Note that if
you rewrite this character string by
mistake, you may be unable to use
the group function of that MD.
Notes
• The group function setting is stored even if
you eject the MD or turn off the recorder.
• In group mode, the recorder treats all tracks
without group settings as belonging to the last
group on the disc. The last group is indicated
in the display window on the recorder as
"GP --". Within a group, the tracks appear in
their order on the disc, not their order within
the group.
30
-GB
2 3
END SEARCH
Control key
(./>/N)
GROUP
To activate group mode
(Group Mode Recording)
To record tracks in group mode, you must
first turn group mode on before the start
of recording.
1
Press GROUP for 2 seconds or more.
" " and "GP ON" light up and
group mode turns on.
To cancel group mode, press GROUP
for 2 seconds or more again.
Recording a track into a new
group
• Turn group mode on.
1
Press END SEARCH while the
recorder is stopped.
2
Press N while pressing REC.
3
Play the source sound.
To stop recording
Press x. The material that was recorded
up until x was pressed is entered as a new
group.
REC