Anderic RRLC16.2 Operating Manual

Anderic

Thank you for purchasing the Anderic RRLC16.2 universal remote control. This remote is

programmed to work with Sharp

via the learning method. Please refer to the "Learning Instructions" section for instructions, no

codes needed. However, if you have any other brand of Roku TV or a Roku Steaming Player, you

can program this remote work via the below table "Programming Codes for Roku TVs."

NOTE: This remote does not work for Roku Sticks

Downloadable (PDF) version of this manual is available at:

Installing batteries and the wrist strap

Please see the diagram below.

1. Remove the battery cover.

2. Insert the batteries, as shown in the diagram below, matching polarities.

3. Loop the wrist strap around the screw hole and hold in place while

replacing the battery cover.

RRLC16.2 Advanced Universal

Operating Guide

Roku

TVs. This remote can be programmed to work any TV

ANDERIC.COM/RRLC16

Table of Contents

Do you have a question about the RRLC16.2 and is the answer not in the manual?

Page 1 ® Anderic RRLC16.2 Advanced Universal Operating Guide Thank you for purchasing the Anderic RRLC16.2 universal remote control. This remote is programmed to work with Sharp ® Roku ® TVs. This remote can be programmed to work any TV via the learning method. Please refer to the “Learning Instructions” section for instructions, no codes needed.
Page 2 Programming Codes for Roku TVs Use the codes below to program to Roku TVs (TVs manufactured by one of the brands below with built-in Roku software). Steps: 1. Take note of the two keys to press from the “Code” column corresponding with your TV brand from the “Brand”...
Page 3 1-2 inches apart (both remotes should be pointing at each other). 3. On the RRLC16.2, Press and release the first key to be learned, the indicator light will now flash slowly. 4. On the original remote, press and hold the key that you want to learn to the corresponding key previously pressed on the RRLC16.2.
Page 4 Press and hold the key on the original remote until the RRLC16.2 indicator light flashes three times and then remains on. Press & keys to save and exit. The key is now programmed to the RRLC16.2 and should operate your unit.