Draining The Brewer; High Altitude Use; Authorized Service - Bunn A-10 Use And Care Manual

The water in your Bunn
on a trip, shipped, or stored in an unheated location with a chance of freezing.
1) Unplug the brewer and cool the hot water in the tank.
Place the empty decanter on the warmer. Simply pour a
full water pitcher of cold water into the top of the brewer,
close the lid and wait for the water to stop fl owing from
the funnel. Empty the decanter, repeat. This will cool the
water in the tank.
2) Remove sprayhead by turning counterclockwise with your
fi ngertips and set it aside.
3) Grasp the back of the brewer and quickly turn it upside
down over a sink as shown. Most of the water in the tank
will fl ow from the sprayhead opening but some water may
fl ow from the area around the top lid. Continue tipping
the brewer until the fl ow of water ceases.
4) Reinstall the sprayhead when all water has drained from
the brewer. Securely tighten it by turning clockwise.
NOTE: Refer to "PREPARING THE BREWER FOR USE" before us-
Your Bunn ® Pour-Omatic
of the country. For high altitude use, over 5000 feet, the model A10-D should be
used.
For service (whether or not warranty is still in effect), drain the brewer, carefully
pack it so it is fully protected against breakage and send it to one of the authorized
Bunn-O-Matic facilities listed below:
Bunn-O-Matic Corporation
Retail Products Division
1400 Stevenson Drive
Springfi eld, Illinois 62703
(800) 352-2866

DRAINING THE BREWER

® Coffee Brewer should be emptied whenever it is taken
ing the brewer.

HIGH ALTITUDE USE

® Coffee Brewer is designed to operate in most areas

AUTHORIZED SERVICE

Bunn-O-Matic Corporation
Cerritos, California 90701
10
Retail Products Division
16431 Carmenita Road
(800) 637-2866
10070 010704
P2084
P2082