Repeat the steps 6 and 7 on all the buttons
you want to learn. You can learn the button
with a red frame.
If you want to change the name of the panel,
click the panel name. The screen to edit the
panel name appears. Enter a new name and
To complete learning, click
remote control panel.
A confirmation screen appears. Click [OK]
to return to the settings screen. A mark
appears on the generic panel name in the
Click [OK] to close the settings window.
• When you want to erase all data, select the generic
panel and click [Reset] on the settings window.
• If the screen does not disappear, make sure that you
are correctly aiming the remote at the IR Receiver of
the Base Station.
• Avoid locations in direct sunlight or under strong
illumination when sending the remote signal.
• After setting up the learning remote, check to see if
it works correctly by using the on-screen remote of
the video 1/2.
• If you connect to the Base Station LF-B1 or LF-X11,
you can also set up on-screen remote for TV. For
details on how to set them up, refer to the operating
instructions of your Base Station.
Downloading the Additional Remote
If you cannot find your external device in the list,
you can download the Additional Remote
Control Data from Additional Remote Control
Data Download Service site.
Before you begin:
Once the software has been installed, you will
have the necessary shortcut to the folder
'LocationFree RC_DATA' on your desktop.
(1 page 7)
Downloading and installing the
Additional Remote Control Data:
You can download the Additional Remote
Control Data of your device from the
Additional Remote Control Data Download
Service site, and then save the file into the
'LocationFree RC_DATA' folder.
You can select the make and type of the file
downloaded from the list on Remote
Settings. (1 page 16)
For more detail information and settings, please
refer to the following website:
You can change the screen mode of the video of
the LocationFree Player.
Click anywhere in the window to display the
bottom bar, then select [Settings] at the
bottom of the window.
Select the [Screen Mode] under the [Video
Settings] of the [Settings] screen.
The screen to set the screen mode appears.