Specifications - Sony STR-DG910 Operating Instructions Manual

If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 32). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
See
page 32
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
page 66
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
1)
Measured under the following conditions:
120 V AC, 60 Hz
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Frequency response
Analog
Input
Analog
Digital (Coaxial) Impedance: 75 ohms
Digital (Optical) S/N: 100 dB
1)
100 W + 100 W
110 W + 110 W
2)
150 W per channel
10 Hz – 70 kHz,
+0.5/–2 dB (with sound
field and equalizer
bypassed)
Sensitivity: 500 mV/
50 kohms
3)
S/N : 96 dB
4)
(A, 500 mV )
S/N: 100 dB
(A, 20 kHz LPF)
(A, 20 kHz LPF)
continued
97 US