Surround Speaker Position - Sony STR-DG910 Operating Instructions Manual

x SUR POS.

(Surround speaker position)

Lets you specify the location of your surround
speakers for proper implementation of the
surround effects in the CINEMA STUDIO EX
modes (page 63). This parameter is not
available when the surround speakers are set to
"NO" (page 48).
• SIDE/LO
Select if the location of your surround
speakers corresponds to sections A and C.
• SIDE/HI
Select if the location of your surround
speakers corresponds to sections A and D.
• BEHD/LO
Select if the location of your surround
speakers corresponds to sections B and C.
• BEHD/HI
Select if the location of your surround
speakers corresponds to sections B and D.
Tip
Surround speaker position is designed specifically
for implementation of the CINEMA STUDIO EX
modes. For other sound fields, speaker position is
not so critical.
Those sound fields were designed under the premise
that the surround speakers would be located behind
the listening position, but presentation remains
fairly consistent even with the surround speakers
positioned at a rather wide angle. However, if the
speakers are pointing toward the listener from the
immediate left and right of the listening position, the
surround effects become unclear unless set to
"SIDE/LO" or "SIDE/HI".
Nevertheless, each listening environment has many
variables, such as wall reflections, and you may
obtain better results using "BEHD/HI" if your
speakers are located high above the listening
position, even if they are located to the immediate
left and right.
Therefore, although it may result in a setting
contrary to the above explanation, we recommend
that you play back multi channel surround encoded
software and select the setting that provides a good
sense of spaciousness and that best succeeds in
forming a cohesive space between the surround
sound from the surround speakers and the sound of
the front speakers. If you are not sure which sounds
best, select "BEHD/LO" or "BEHD/HI" and then
use the speaker distance parameter and speaker level
adjustments to obtain proper balance.
x CRS. FREQ (Speaker crossover
frequency)
Lets you set the bass crossover frequency of
the speakers that have been set to "SMALL" in
the SYSTEM menu. This parameter is only
available when at least one speaker is set to
"SMALL".
Note
This parameter is not available when "CAL LOAD"
is set to "LOAD YES" in A. CAL menu. In this case,
set to "LOAD NO".
x DIMMER (Brightness of the
display)
Lets you adjust the brightness in 3 steps.
59 US