3A: Connecting The Audio Components - Sony STR-DG910 Operating Instructions Manual

a)
If you have an additional front speaker system,
connect them to the SPEAKERS FRONT B
terminals. You can select the front speakers you
want to use with the SPEAKERS (OFF/A/B/A+B)
button on the receiver (page 33).
b)
If you have an additional sub woofer, connect it to
any of the SUB WOOFER jacks. You can connect
up to 4 sub woofers.
c)
If you connect only one surround back speaker,
connect it to the SPEAKERS SURROUND
BACK L terminals.
d)
When you connect a sub woofer with an auto
standby function, turn off the function when
watching movies. If the auto standby function is
set to on, it turns to standby mode automatically
based on the level of the input signal to a sub
woofer, then sound may not be output.
3a: Connecting the audio
components
How to connect your
components
This section describes how to connect your
audio components to this receiver. Before you
begin, refer to "Component to be connected"
below for the pages which describe how to
connect each component.
After connecting your audio component,
proceed to "3b: Connecting the video
components" (page 20) or "4: Connecting the
antennas" (page 31).
Component to be connected
Component With
Super Audio Digital audio output
CD player/
Analog audio output
CD player/
b)
only
CD recorder
MD deck, Analog audio output
b)
tape deck, only
etc.
a)
Model with DIGITAL COAXIAL OUTPUT jack
etc.
b)
Model equipped only with AUDIO OUT L/R
jacks, etc.
Page
a)
18
19
19
17 US