Chapter 2 Hardware Configuration; Pin Assignment; Jumper Setting: Jp6 - Korenix JetBox 8152 User Manual

Chapter 2 Hardware Configuration

2-1

Pin Assignment

The CANBUS is use DB9 standard connector. The following tables show the
CANBUS signal connections of this connector.
Note 1: The CANBUS DB9-pin out conforms to the ISO 11898/2 standard
2-2

Jumper Setting: JP6

    JP6: CANBUS Terminal Resistor Selection
Note 2: The JP6 is the CANbus termination jumper. Only two termination
jumpers should be closed at the endpoints of the CANbus. Value Terminator Resistor
(120 Ω). The minimum speed is 20k bps. The maximum speed is 1M bps. But when
CANBUS terminator is disabled, the maximize speed of CANBUS is
want to use high speed (1M bps), please enable terminator.
DB-9 CANBUS
CANBUS Signal
1 N.C
6 N.C
2 CAN-L
7 CAN-H
3 CAN-Ground
8 N.C
4 N.C
9 N.C
5 Ground
Case Case Ground
CANBUS
Description
-
-
Dominant Low
Dominant High
Isolated Ground
-
-
-
Digital Ground
125k
Korenix | Hardware Configuration
Factory preset
bps. If you
6