Troubleshooting; Warranty; Disposal - Kampa Geyser Installation And Operating Manual

Troubleshooting

Fault
Water will not flow from
shower head.
Burner will not light.
Water is not hot enough. The inlet water is too cold. The appliance

Warranty

The statutory warranty period applies. If the
product is defective, please contact the
manufacturer's branch in your country (see
kampaoutdoors.com/store-locator) or your
retailer.
For repair and warranty processing, please include
the following documents when you send in the
device:
• A copy of the receipt with purchase date
• A reason for the claim or description of the fault
16
Possible cause
The appliance is switched off.
Water supply is insufficient.
The water pump is not connected to the
appliance.
DC power supply is not adequate.
The shower head switch is in "OFF"
position.
Water is not flowing from the shower head. Turn the shower head switch to "ON"
The inlet water is over +50 °C warm.
The gas cylinder is turned off.
There is no gas in the gas cylinder.
can raise the water temperature by approx.
25 °C.
The over-temperature safety appliance has
been triggered.

Disposal

➤Place the packaging material in the appropriate
recycling waste bins, wherever possible.
M
If you wish to finally dispose of the product,
ask your local recycling center or specialist
dealer for details about how to do this in
accordance with the applicable disposal
regulations.
4445103340
Solution
Switch on the appliance.
Provide sufficient water supply.
Connect the water pump to the appliance.
Provide adequate DC power supply.
Turn the shower head switch to "ON"
position.
position.
Let the inlet water cool down below
+50 °C.
Turn the gas cylinder on.
Exchange the gas cylinder.
Recirculate the water until desired
temperature is reached.
Let the system cool down until the over
temperature safety switch opens.