Assembly; Handle - Craftsman C459-36306 Operator's Manual

21” self-propelled lawn mower
Table of Contents

Advertisement

IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After
assembly, service engine with gasoline and oil as instructed in the
separate engine manual packed with your unit.
NOTE: Reference to right, left, rear and front of the lawn mower is in
relation to the operating position.

Handle

1.
Remove any packing material which may be between upper and
lower handles.
a.
Remove wing nuts and carriage bolts from handle as shown
in Figure 1. Do not loosen or remove adjacent hex head
screws.
A
b.
While stabilizing mower so it doesn't move, pivot upper
handle up as shown in Figure 2. Do not crimp cable while
lifting the handle up.
2.
Remove the T-bolts from the handle brackets as shown in Figure 3.

ASSEMBLY

A
Figure 1
B
Figure 2
3.
Follow the steps below to complete handle assembly:
a.
Pull upward on the handle until holes in lower handle (shown
in Figure 3 deck cutaway) line up with holes in handle
bracket. See Figure 4.
NOTE: When pulling upward on handle, make sure to not
pull handle all the way out.
b.
Insert the T-bolts removed earlier through the handle
brackets and lower handle and tighten securely to secure the
handle in place. See Figure 4.
A
B
9
Figure 3
B
Figure 4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents