Tv Virtual Surround Sound Settings (Tvs) - Sony DVP-NS300 Operating Instructions (CD/DVD Component) Operating Instructions Manual

Dolby Digital 3 ch
DOLBY DIGITAL
Front (L/R) Rear
PCM (Stereo)
Sampling frequency
PCM 96kHz 24bit
Quantized bit rate
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
Front (L)
Front (R)
Center
Rear (L)
Rear (R)
Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound's
monaural rear audio signals.
LFE (Low Frequency Effect) signal
Note
If "DTS" is set to "OFF" in "AUDIO SETUP," the
DTS track selection option will not appear on the
screen even if the disc contains DTS tracks (page 59).
2 / 1
(monaural)
TV Virtual Surround Sound
Settings
(TVS)
When you connect a stereo TV or 2 front
speakers, TV Virtual Surround lets you enjoy
surround sound effects by using sound
imaging to create virtual rear speakers from
the sound of the front speakers (L: left, R:
right) without using actual rear speakers.
This function is designed to work with the
LINE OUT L/R (AUDIO) 1/2 jacks.
Note that if you select one of the TVS settings
while playing a DVD, the player does not
output Dolby Digital signals from the
DIGITAL OUT (COAXIAL and OPTICAL)
jacks (when you set "DOLBY DIGITAL" in
"AUDIO SETUP" to "D-PCM") (page 59).
SURROUND
1
Press SURROUND during
playback.
The Control Bar is displayed.
TVS DYNAMIC
2
Press SURROUND repeatedly to
select one of the TVS (TV Virtual
Surround) sounds.
Refer to the explanations given for each
item.
TVS DYNAMIC
TVS WIDE
TVS NIGHT
TVS STANDARD
continued
43