Dell 2200 User Manual page 147

Message
Keyboard controller
error
EISA configuration
NVRAM bad
EISA configuration
error
Invalid CPU speed
detected - Check jump-
ers
Memory size limit
exceeded
Processor bus termina-
tor not installed
Warning: Processor is
not installed in Pro-
cessor 1 slot.
Processor X tempera-
ture sensor is not
installed.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
Table F-1. System Error Messages (continued)
Probable Cause
A cable or connector may be
loose, or the keyboard or
keyboard controller may be
faulty.
The EISA jumper may have
been accidentally installed.
The EISA configuration
data in NVRAM does not
match the installed EISA
expansion cards.
The microprocessor speed
jumper plug may be absent
or installed on the wrong
jumper pins.
The size of installed DIMM
memory is greater than
512 megabytes (MB).
In a single-microprocessor
system, a terminator card is
not installed in the secondary
microprocessor connector.
No microprocessor module
is installed in the primary
microprocessor connector.
The primary (X=1) or sec-
ondary (X=2) microproces-
sor's temperature sensor is
not connected to the system
board.
Corrective Action
Check the keyboard cable and connector for
proper connection. If the problem persists, run
the Keyboard Test Group in the diskette-
based diagnostics to determine whether the
keyboard or the keyboard controller is faulty.
See the chapter titled "Running the Diskette-
Based Diagnostics" in your Diagnostics and
Troubleshooting Guide.
Remove the EISA jumper, reboot the system,
and restore the EISA configuration parameters.
See "Starting the EISA Configuration Utility" in
Chapter 5.
Verify that any installed EISA expansion cards
are properly seated, and then run the EISA con-
figuration utility to verify that the configuration
parameters are correct. See the chapter titled
"Using the EISA Configuration Utility."
Check the microprocessor speed jumpers. See
Table B-1 in Appendix B.
Verify that the total installed DIMM memory
does not exceed 512 MB. See "Adding Mem-
ory" in Chapter 7.
Install a terminator card in the secondary micro-
processor connector. See "Installing a
Microprocessor" in Chapter 7.
Move the microprocessor to the primary micro-
processor connector. See "Installing a
Microprocessor" in Chapter 7.
Connect the microprocessor's temperature sen-
sor to the appropriate connector on the system
board. See "Installing a Microprocessor" in
Chapter 7.
Beep Codes and System Messages F-3