Before You Begin; Removing And Replacing Front-Panel Inserts; Removing And Replacing Plastic Inserts; Figure 8-1. External Drive Bay Hardware - Dell 2200 User Manual

diskette drive interface cable

Figure 8-1. External Drive Bay Hardware

B
efore You Begin
In order to remove or install drives in the external bays,
you must remove the computer cover and front bezel
according to the instructions in "Removing the Computer
Cover" and "Removing the Front Bezel" in Chapter 6.
R
emoving and Replacing Front-
Panel Inserts
To protect the inside of the computer from foreign parti-
cles, a plastic front-panel insert covers each empty
external drive bay. Additionally, each empty drive bay is
covered by a metal insert to maintain the necessary elec-
tromagnetic interference (EMI) shielding for the chassis.
8-2 Dell PowerEdge 2200 Systems User's Guide
power input connector
Before you install a drive in an empty bay, you must first
remove the plastic and metal inserts.
Whenever you remove a drive, be sure to replace the
metal insert on the chassis and then replace the plastic
insert in the front bezel to cover the empty bay.

Removing and Replacing Plastic Inserts

To remove the plastic insert for a drive bay you intend to
use, first remove the front bezel as instructed in "Remov-
ing the Front Bezel" in Chapter 6. Then, facing the inside
of the front bezel, grasp the front bezel with both hands
and place your fingers on the outside of the front-bezel
insert (as indicated by the two arrows in Figure 8-2).
Push on the outside of the front-bezel insert while twist-
ing the sides of the front bezel outward until the front-
bezel insert is released.
diskette drive
CD-ROM drive
DC power cable
SCSI interface cable