Download  Print this page

Getting Started; Printing A Demo Page; System Requirements; Microsoft® Windows - Dell 1230c User Manual

Color laser printer.
Hide thumbs

Advertisement

getting started

This chapter gives you step-by-step instructions for setting up the printer.
This chapter includes:
Setting up the hardware

Printing a demo page

System requirements

SETTING UP THE HARDWARE
This section shows the steps to set up the hardware which is explained in
the Quick Install Guide. Ensure that you read Quick Install Guide and
complete following steps.
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open covers and trays.
The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the printer close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing. See "Altitude adjustment" on
page 16 for more information.
Place the printer on a flat and stable surface, not letting it lean more than
2 mm (0.08 inches). Otherwise, it may affect the printing quality.
2. Unpack the printer and check all the enclosed items.
3. Remove the tape holding the printer tightly.
4. Load paper. (See "Changing the size of the paper in the paper tray" on
page 20.)
14 | Getting started
Installing the software
printer's basic settings
5. Ensure that all the cables are connected to the printer.
6. Turn the printer on.
When you move the printer, do not tilt or turn it upside down.
Otherwise, the inside of the printer may be contaminated by toner,
which can cause damage to the printer or produce bad print quality.
PRINTING A DEMO PAGE
Print a demo page to ensure that the printer is operating correctly.
To print a demo page:
In Ready mode, press and hold the
SYSTEM REQUIREMENTS
Before you begin, ensure that your system meets the following
requirements:
Microsoft® Windows®
Your printer supports the following Windows operating systems.
REQUIREMENT (RECOMMENDED)
OPERATING
SYSTEM
CPU
Windows
Intel® Pentium® II 400 MHz
(Intel Pentium III 933 MHz)
2000
Windows XP
Intel Pentium III 933 MHz
(Intel Pentium IV 1 GHz)
Windows
Intel Pentium III 933 MHz
(Intel Pentium IV 1 GHz)
2003 Server
Windows
Intel Pentium IV 3 GHz
Vista®
Windows
Pentium IV 1 GHz (Pentium IV
2 GHz)
Server 2008
Internet Explorer 6.0 or higher is the minimum requirement for all
Windows operating systems.
Users who have an administrator rights can install the software.
Windows Terminal Services is compatable with this machine.
Stop button for about 2 seconds.
FREE HDD
RAM
SPACE
128 MB
600 MB
(256 MB)
128 MB
1.5 GB
(256 MB)
128 MB
1.25 GB to
(512 MB)
2 GB
512 MB
15 GB
(1024 MB)
512 MB
10 GB
(2048 MB)

Advertisement

Chapters

Table of Contents

   Related Manuals for Dell 1230c

This manual is also suitable for:

1230 color laser

Comments to this Manuals

Symbols: 0
Latest comments:
  • Blanca Dec 04, 2015 10:32:
    is there any way to get a Service Manual for a Dell Laser 1320c printer...​? I only see user manuals.