Using Dell Pc Restore By Symantec - Dell XPS M1210 Owner's Manual

Enabling System Restore
If you reinstall Windows XP with less than 200 MB of free hard-disk space available, System Restore is
automatically disabled. To see if System Restore is enabled:
1 Click the Start button and click Control Panel.
2 Click Performance and Maintenance.
3 Click System.
4 Click the System Restore tab.
5 Ensure that Turn off System Restore is unchecked.

Using Dell PC Restore by Symantec

NOTICE:
Using Dell PC Restore permanently deletes all data on the hard drive and removes any application
programs or drivers installed after you received your computer. If possible, back up the data before using
PC Restore. Use PC Restore only if System Restore (see "Using Microsoft Windows XP System Restore" on
page 108) did not resolve your operating system problem.
NOTE:
Dell PC Restore by Symantec may not be available in certain countries nor on certain computers.
Use Dell PC Restore by Symantec only as the last method to restore your operating system. PC Restore
restores your hard drive to the operating state it was in when you purchased the computer. Any programs
or files added since you received your computer—including data files—are permanently deleted from the
hard drive. Data files include documents, spreadsheets, e-mail messages, digital photos, music files, and
so on. If possible, back up all data before using PC Restore.
To use PC Restore:
1 Turn on the computer.
During the boot process, a blue bar with www.dell.com appears at the top of the screen.
2 Immediately upon seeing the blue bar, press <Ctrl><F11>.
If you do not press <Ctrl><F11> in time, let the computer finish starting, and then restart the
computer again.
NOTICE:
If you do not want to proceed with PC Restore, click Reboot in the following step.
3 On the next screen that appears, click Restore.
4 On the next screen, click Confirm.
The restore process takes approximately 6–10 minutes to complete.
5 When prompted, click Finish to reboot the computer.
NOTE:
Do not manually shut down the computer. Click Finish and let the computer completely reboot.
110
Troubleshooting