Removing And Installing Media Bay Devices - Dell Latitude D531 User Manual

Removing the Device Security Screw
If the device security screw is installed, you must remove the screw to remove the device from the bay:
1 Save and close any open files, exit any open programs, and shut down the computer.
2 If the computer is connected to a docking device (docked), undock it. See the documentation that
came with your docking device for instructions.
3 Close the display and turn the computer over.
4 Use a #1 Phillips screwdriver to remove the device security screw from the bottom of the computer.

Removing and Installing Media Bay Devices

NOTICE:
When removing or installing a device, avoid dropping the device as this may damage the drive. Store the
device in a safe, dry place when it is not installed in the computer. Avoid pressing down on the device or placing
heavy objects on top of it.
NOTE:
If your computer shipped with a device security screw and the screw is not installed, you can remove and
install devices while the computer is running and connected to a docking device.
1 If you are swapping a device while the computer is turned on, double-click the Safely Remove Hardware
icon on the taskbar, click the device that you want to eject, and click Stop.
If you are swapping a device while the computer is turned off, proceed to the next step.
2 If your computer shipped with a device security screw and the screw is installed, remove it (see "About
the Device Security Screw" on page 125).
3 Press the device latch release.
126
Before You Begin
1
1 device security screw
2
2 device latch release