Dell Latitude D531 User Manual page 112

CAUTION:
Before working inside your computer, follow the safety instructions located in the Product
Information Guide.
NOTICE:
To prevent data loss, turn off your computer before removing the hard drive (see "Turning Off Your
Computer" on page 109). Do not remove the hard drive while the computer is on, in standby mode, or in hibernate
mode.
NOTICE:
Hard drives are extremely fragile; even a slight bump can damage the drive.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE:
You need the Operating System media to install the Microsoft
the Drivers and Utilities media for your computer to install the drivers and utilities on the new hard drive.
To replace the hard drive in the hard drive bay:
1 Follow the procedures in "Before You Begin" on page 109
2 Turn the computer over, and remove the hard drive screws.
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting
Against Electrostatic Discharge" in the Product Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the
connector.
5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
112
Before You Begin
® ®
Windows operating system. You also need
1
2