Dell Inspiron 1720 Owner's Manual page 109

X T E N D E D M E M O R Y S I Z E H A S C H A N G E D
E
NVRAM does not match the memory installed in the computer. Restart the
computer. If the error appears again, contact Dell (see "Contacting Dell" on
page 179).
H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E
T
that you are trying to copy is too large to fit on the disk, or the disk is full. Try
copying the file to a different disk or use a larger capacity disk.
A F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
Do not use these characters in filenames.
> | —
A T E F A I L U R E
G A 2 0
modules and, if necessary, replace them (see "Memory" on page 147).
G E N E R A L F A I L U R E
command. The message is usually followed by specific information—for
example, Printer out of paper. Take the appropriate action.
H A R D - D I S K D R I V E C O N F I G U R A T I O N E R R O R
drive type. Shut down the computer, remove the hard drive (see "Hard Drive"
on page 139), and boot the computer from a CD. Then, shut down the
computer, reinstall the hard drive, and restart the computer. Run the Hard
Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 99).
A R D D I S K D R I V E C O N T R O L L E R F A I L U R E
H -
to commands from the computer. Shut down the computer, remove the hard
drive (see "Hard Drive" on page 139), and boot the computer from a CD.
Then, shut down the computer, reinstall the hard drive, and restart the
computer. If the problem persists, try another drive. Run the Hard Disk Drive
tests in the Dell Diagnostics (see "Dell Diagnostics" on page 99).
A R D D I S K D R I V E F A I L U R E
H -
from the computer. Shut down the computer, remove the hard drive (see
"Hard Drive" on page 139), and boot the computer from a CD. Then, shut
down the computer, reinstall the hard drive, and restart the computer. If the
problem persists, try another drive. Run the Hard Disk Drive tests in the Dell
Diagnostics (see "Dell Diagnostics" on page 99).
H A R D - D I S K D R I V E R E A D F A I L U R E
down the computer, remove the hard drive (see "Hard Drive" on page 139),
and boot the computer from a CD. Then, shut down the computer, reinstall
the hard drive, and restart the computer. If the problem persists, try another
drive. Run the Hard-Disk Drive tests in the Dell Diagnostics (see "Dell
Diagnostics" on page 99).
A memory module may be loose. Reinstall the memory
—
The operating system is unable to carry out the
—
The hard drive does not respond to commands
—
—
The amount of memory recorded in
—
The computer cannot identify the
—
The hard drive does not respond
0 —
The hard drive may be defective. Shut
The file
—
: \ / : * ? " <
Troubleshooting
109