Table of Contents
Advertisement
5.4. Placement of Solar Collectors
Place one of the solar collectors in the support frame, place it first on the lower
profile cross-E1 or E2 and then on the higher profile cross- E1 or E2. Adjust the
position of the solar collector in the structure, so that matches the holes in the
structure of the holes in the rear part of the collector (Figure 17).
that the end is introduced into the connector. Verify that the connection has been
done correctly and that the holes in the structure match those holes back of the
collectors. Adjust the position of the collectors if necessary.
Adjust the higher cross- E1 or E2 profile to the collectors and tighten the bolts that
bind to the longitudinal profiles D3.
Screw the solar collectors to the structure, with the bolts M6x20 (four per collector)
with their washers.
Make sure all bolts and the different elements of the structure are properly tightened
and check the solidity of the whole and its correct fixing to the bench. The collectors
and the support system can withstand wind velocity up to 120km/h and weight of
snow up to 80cmheight at 45 degrees.
The bank of two solar collectors is ready to start the hydraulic connections.
Figure 17.
Figure 18.
Remove the protection caps
of the collector lateral'
connections and introduce
the two compression union
connectors (see fig. 5).
Remove the protection caps
of the connections of the
lateral of the second
collector and place it on the
structure, on the cross
profiles E1 or E2 lower and
upper.
Slide the second collector so
Page 16 of 24
Advertisement
Table of Contents
