Removing Cards - Dell Dimension 4300 Solution Manual

2H930bk1.book Page 72 Tuesday, November 20, 2001 5:02 PM
FILE LOCATION: C:\Projects\Green_Lantern_solutions\2H930c31.fm FILE LOCATION: FILE LOCATION: FILE LOCATION:
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1 D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1 D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1 D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1
72 Ad d i n g Par ts

Removing Cards

CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside
Your Computer" on page 12.
Shut down the computer (see page 20).
1
Turn off any attached devices and disconnect them from their
2
electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
Disconnect the computer power cable from the wall outlet, and then
3
press the power button to ground the system board.
Open the computer cover (see page 65).
4
If necessary, disconnect any cables connected to the card.
5
To raise the securing lever, press the tab until it is free from the latch
6
and then lift the lever.
securing lever
card
bracket
tab
back of computer
latch