Dell Dimension 2400 Series Owner's Manual page 58

13
Check all cable connections, and fold cables out of the way to provide airflow for the fan and
cooling vents.
14
Replace the computer cover (see page 68).
NOTICE:
the computer.
15
Connect your computer and devices to electrical outlets, and turn them on.
16
After you turn on your computer, press <F2> when you are prompted to enter setup mode.
17
Highlight Drive Configuration and press <Enter>.
18
Use the left and right arrows to change Diskette Drive A from Not Installed to 3.5 inch,
1.44 MB.
19
Press <Enter>.
20
Highlight Integrated Devices (LegacySelect Options) and press <Enter>.
21
Ensure that the Diskette Interface entry is set to Auto. If necessary, use the left and right
arrows to set it to Auto.
58
Removing and Installing Parts
side hinges (3)
To connect a network cable, first plug the cable into the network wall jack and then plug it into
front panel