Troubleshooting - Husqvarna PG 540 Operator's Manual

3. Push the chassis fully against the grinding head (A).
B
A
4. Install the lock bolts (B) on each side of the grinding
head.
5. Attach the locking pins (C) on each side of the
grinding head.
Problem
The product does not
start.
18
C

Troubleshooting

Cause
The extension cable is disconnected or dam-
aged.
An emergency stop button is engaged.
The safety switch is open in the electrical en-
closure.
6. Connect the motor cable from the chassis with the
motor cable from the motor (D).
7. Tighten the locknut (E) on the motor cable from the
chassis clockwise.
8. Put the motor cables into the cable holder (F).
9. Remove the grinding head in opposite sequence.
Solution
Connect the extension cable or if it is neces-
sary, replace the extension cable.
Turn the emergency stop button on the con-
trol panel clockwise to disengage.
Close the safety switch to complete the cir-
cuit.
D
1211 - 003 - 22.01.2020
E
F