t t a a b b l l e e o o f f c c o o n n t t e e n n t t s s L L i i m m i i t t e e d d L L i i f f e e t t i i m m e e C C o o n n s s u u m m e e r r W W a a r r r r a a n n t t y y ........i W W h h a a t t I I s s I I n n c c l l u u d d e e d d .
w w h h a a t t i i s s i i n n c c l l u u d d e e d d ➤ ➤ The control module ➤ ➤ Two four-button transmitters ➤ ➤ The red LED status indicator light ➤...
last approximately one year under normal use. When the battery begins to weaken, operating range will be reduced and the LED on the remote will dim. ➜ your warranty Your warranty registration must be completely filled out and returned within 10 days of purchase. Your product warranty will not be validated if your warranty registration is not returned.
t t r r a a n n s s m m i i t t t t e e r r f f u u n n c c t t i i o o n n s s The receiver uses a computer-based learn routine to learn the transmitter buttons.
Button An optional convenience or expansion option that you have added to your system can be activated by pressing auxiliary output controls__________________________. u u s s i i n n g g y y o o u u r r s s y y s s t t e e m m ➜...
Page 9
DOORS LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST AT ALL TIMES REMAIN CLOSED. These precautions are the sole respon- sibility of the user. ➤ ➤ Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death.
dealer. OPERATION OF THE REMOTE ENGINE STARTING MODULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION. OPERATING THE REMOTE ENGINE STARTING SYSTEM UNDER THESE CONDITIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IMMEDIATELY CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED DEALER TO REPAIR OR DISCON- NECT...
off. After the ignition has been turned off, the LED status indi- cator will flash rapidly to indicate that the system is in Passive Mode. If Passive Mode has been programmed on, then it is also possible to program the system for Passive Locking. With Passive Locking, the doors lock automatically at the same time that the starter inter- rupt is activated.
the vehicle's ignition key and know where the Valet switch is located. Be sure to check with the installer for the location of the Valet switch. To override the starter interrupt: Turn the ignition on and press the Valet switch within 10 seconds. The LED status indicator will stop flashing and the vehicle should start.
➜ panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter. Just press and hold for 1.5 seconds to enter Panic Mode. In Panic Mode, the horn will honk and the parking lights will flash for 30 seconds.
3. Release the button as soon as the parking lights flash. (In gasoline vehicles, the engine will start 3 seconds after the parking lights flash. In diesel vehicles, the engine will start when the wait-to-start indicator on the vehicle's dash goes out.) 4.
➤ ➤ The shutdown toggle switch is put into the OFF position. ➤ ➤ The pre-programmed run time (12, 24, or 60 minutes) has elapsed. ➤ ➤ is pressed during remote start operation. To shut down the remote start and turn off the engine: ➤...
note: This feature will not work if the brake pedal is being pressed. ➜ timer mode Timer Mode automatically starts and runs the engine for a pre- programmed time period, every three hours for a total of six operation cycles. This feature helps to ensure that your engine will start in the morning after a night of extremely cold temperatures.
To exit Timer Mode: Timer Mode can be exited by turning the ignition on with the key any time the engine is not running. You can also exit Timer Mode with the remote transmitter by following these steps: 1. Start the engine by pressing 2.
start, move the shutdown toggle switch to the OFF position. The switch can be installed in a location of your choice. Check with your installer for recommended locations. Location of Shutdown Switch____________________________ s s m m a a r r t t p p o o w w e e r r u u p p I I I I This system will store its current state to non-volatile memory.
➤ ➤ Parking lights flashing programmed to either flash or to turn on the parking lights constantly during the entire remote start operation. ➤ ➤ Passive Mode or Active Mode starter interrupt will automatically activate 30 seconds after the ignition has been turned off. ➤...
An automatic switch controlled by your system Starter Interrupt: which prevents the vehicle’s starter from cranking whenever the system is armed. The vehicle is never prevented from cranking when the system is disarmed, in Valet Mode, or if the starter interrupt switch itself fails.
Page 21
system to be operated from any touch tone telephone. Directed ® ’s AVL system shares the same basic Car*Com features, but takes remote vehicle paging one step further by providing web-enabled two-way GPS vehicle location services, including “bread crumb” tracking and geo-fencing capabilities. The domelight will illuminate for 30 Domelight Supervision: seconds each time the system is disarmed using the remote.
Page 22
two windows both up and down. The 530T also provides one touch switch operation. For added security, your system can Progressive Door Unlocking: be configured to unlock the driver’s door only, leaving the passenger doors locked. Pressing the unlock button an additional time will unlock the passenger doors.
q q u u i i c c k k r r e e f f e e r r e e n n c c e e g g u u i i d d e e To lock/arm using your remote ➤...
Page 25
The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide consumers with the finest ® vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, Directed ®...
Need help?
Do you have a question about the Matrix RS and is the answer not in the manual?
Questions and answers