Programming Alarm System Features - Avital Diablo 2 Owner's Manual

Programming Alarm System Features

All programmable alarm features are accomplished by turning the ignition
key on (or starting the vehicle) and flicking the valet switch on and off a
preset number of times.
1. Remove the alarm from Valet Mode. Programming cannot be accessed
while the alarm is in Valet Mode, indicated by the LED on solid red.
2. Select the feature you wish to program from the "Programming Table for
Alarm Features." Note the number of chirps.
3. Turn the ignition key to the "ON" position.
4. Within 10 seconds, begin flicking the valet switch on and off. The siren
will chirp one time each time you flick the switch on, then off.
5. Continue flicking the switch on and off until you reach the number of
chirps associated with your chosen feature.
NOTE: Stop on the chirp.
6. After a 3 second pause, you will hear 1 or 2 chirps to confirm that you
have changed the setting of that feature.
7. Turn the ignition key off.
8. Repeat steps 1-7 for any other feature you wish to program.
Pro gram ming Ta ble for Alarm Fea tures
Fac tory
Fea ture
Set ting
Passive/Active
Passive
Arming
Passive Door
OFF
Locking
Remote Arming
ON
Siren Chirps
Diablo
# of
Chirps
Wait 3 seconds, the siren chirps once for active or
4
Wait 3 seconds, the siren chirps once for OFF or
5
Wait 3 seconds, the siren chirps once for OFF or
6
10
2
/AMX 68/AT-58 Owner's Manual 12/29/97
Sec on dary Ac tion
twice for passive.
twice for ON.
twice for ON.