Desk Installation - Tripp Lite Quad Flat Screen Flex Arm Desk Clamp Owner's Manual

1. Remove the VESA Plates
3mm Hex Key
• Use Hex Key to loosen the screws in order to separate the VESA plate from the Adapter Bracket Assembly.
• Retain these screws for later use.
2. Install the Pole and Desk Clamp Assembly
Bottom
Pole

3. Desk Installation

3a. Edge Installation
Note: min. desktop thickness=10mm (.4")
max. desktop thickness=90mm (3.5")
Note: If more secure clamping pressure is needed for
thinner desktop surfaces, adjust the clamp adjustment
plate by removing the two screws from the desk clamp
assembly, then align the clamp adjustment plate with
the desk clamp assembly's upper holes and reattach
using the same screws.
14-06-218-933380.indb 4
tighten
3mm Hex Key
collar
3mm Hex Key
3mm Hex Key
tighten
tighten
4
VESA Plate
VESA Plate
adjust height
tighten
loosen
3mm
Hex Key
loosen
Top
3mm Hex Key
Pole
• Determine approximate location
for mount, keeping in mind
display size, height adjustment
and pitch/roll requirements.
• Slip the desk mount assembly
over the edge of desk so that
clamp fully contacts desk edge.
• Turn the knob to adjust the
clamp to edge of desk and
secure it tightly.
7/24/2014 3:13:53 PM