Zanussi ZFC51400WA User Manual page 9

Problem
The lid doesn't close completely.
The lid is difficult to open.
The lamp does not work.
The compressor operates contin-
ually.
The temperature in the appliance
is too low/too high.
Customer Service
If your appliance is still not working properly
after making the above checks, contact the
nearest service centre.
To obtain fast service, it is essential that when
you apply for it you specify the model and serial
number of your appliance which can be found
either on the guarantee certificate or on the
rating plate located on the external right side of
the appliance.
www.zanussi.com
Possible cause
Food packages are blocking the
lid.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked.
The lamp is defective.
Temperature is set incorrectly.
Large quantities of food to be
frozen were put in at the same
time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The products' temperature is too
high.
Many products are stored at the
same time.
The door has been opened often. Open the door only if necessary.
Products to be frozen are placed
too closely to each other.
Replacing the lamp
1. Disconnect the mains plug from the mains
2. Replace the used lamp with a new lamp of
Arrange the packages in the right
way, see the sticker in the appli-
ance.
Check the valve.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food to cool to room tem-
perature before storing.
Check if the lid closes well and
the gaskets are undamaged and
clean.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
WARNING!
Do not remove the lamp cover at the
time of replacement. Do not operate
the freezer if the lamp cover is
damaged or missing.
socket.
the same power and specifically designed
Solution
9