D-Link AirPro DWL-6000AP Quick Installation Manual page 2

Connecting The DWL-6000AP Multimode
Wireless Access Point To Your Network
A. First, connect the power adapter to the receptor at the back panel of
the DWL-6000AP and then plug the other end of the power adapter to
a wall outlet or power strip. The Power LED will turn ON to indicate
proper operation.
B. Using a Straight-Through Ethernet
cable, insert one end of the cable to the
Ethernet port on the back panel of the
DWL-6000AP and the other end of the
cable to an Ethernet Broadband
Router (i.e., D-Link DI-604) or Switch
(i.e., D-Link DSS-5+). Note: The
computer used to configure the DWL-6000AP must also be connected
to the same Ethernet router or switch.
C. Computers with 802.11b and 802.11a wireless adapters can connect
to the DWL-6000AP. The DWL-650+ AirPlus Wireless Cardbus
Adapter or the DWL-A650 AirPro and the DWL-520+ AirPlus
Wireless PCI Adapter or the DWL-A520 AirPro will connect out
of the box to the DWL-6000AP, using their default wireless settings.
Used to wirelessly
802.11a adapters.
Reset Button
Pressing this button
restores the DWL-
6000AP to its original
factory default settings.
B.
For connecting to a
switch on a local network
with an Ethernet cable.
Wireless Access Point to
an Ethernet Adapter in a
computer, use a Cross-
Over Ethernet cable.
C. Antenna
connect to
802.11b and
LAN Port
A.
Power Adapter
When connecting
the DWL-6000AP
Receptor for