Tftp Client Setup Commands - D-Link DG-102S User Manual

DG-102S VoIP Station Gateway
If only nwdbg ca is typed, this command shows the address.
Parameter(s): <NOTIFY ENTITY, the format can be: localName@[domainName|ip]:port or
[domainName|ip]:port or [domainName|ip]>
nwdbg ca 10.1.40.100:2427
Example:
nwdbg rgw <RGW NAME>
Definition: This command sets the Residential Gateway Name.
If only nwdbg rgw is typed, this command shows the RGW NAME.
Parameter(s): <RGW NAME>
Example: nwdbg rgw [RGW_1]
nwdbg dns <DNS IP>
Definition: This command sets the Domain Name Server's IP address.
If only nwdbg dns is typed, this command shows the DNS IP/STATE.
Parameter(s): <DNS IP>
Example: nwdbg dns 10.1.1.5
nwdbg dns <disable|enable>
Definition: This command turns on/off the DNS function.
If only nwdbg dns is typed, this command shows the DNS IP/STATE
Parameter(s): [disable | enable]
Example: nwdbg dns disable
nwdbg country <code>
Definition: This command provides country code setting interface to config the tone frequency for
different country.
If only nwdbg country is typed, this command shows the COUNTRY CODE
Parameter(s): <0:USA (Default), 1:Japan, 2:Hong Kong, 3:Sweden>
Example: nwdbg country 1
nwdbg config
Definition: This command shows all the configuration settings made by nwdbg commands.
Parameter(s): None.
nwdbg config
Example:
ping <DEST IP> <OPTIONS>
Definition: This command lets the user ping an IP address from the device.
Parameter(s): <DEST IP: The host ip address>
<OPTIONS, -t : Ping the specifed host until stopped (type SPACE).
-n count: Number of echo requests to send.
-w timeout: Timeout in seconds to wait for each reply.
-i interval: The interval in half-seconds between two echo requests.>
Example: ping 10.1.1.6 -n 100 -w 2 -i 1

TFTP Client Setup Commands

When the user enters tftp, the screen will show all commands about the TFTP client:
ggdbg>tftp
tftp srvip <IP ADDRESS>
tftp get <FILENAME>
– set the IP address of TFTP server
– get the remote image file
48