Download Print this page

D-Link DFE-670 TXD Quick Install Manual page 4

10/100 ethernet pc card for windows 2000
Hide thumbs Also See for DFE-670 TXD:

Advertisement

M-DFE-670TXD-NEW.QXD
A P P E N D I X
To check for the proper installation of
your DFE-670TXD, please go to
START > SETTINGS > CONTROL
PANEL>
Double click on the SYSTEM icon.
At the SYSTEM PROPERTIES
window,click on the HARDWARE
tab, and then click on the DEVICE
MANAGER tab.
Your DFE-670TXD will appear under
NETWORK ADAPTERS, as shown.
A P P E N D I X
Connecting Your Network Cable
Category 5 UTP cable can be used for both
Fast Ethernet cabling and for traditional
Ethernet cabling.
Connecting for Fast Ethernet cabling
Cat5 cable is required for Fast Ethernet operation.
The maximum cable length between the DFE-
670TXD and the supporting hub is 300 ft. The
cable must be straight (not a crossover cable),
with an RJ-45 plug at each end.
Connecting for traditional (10Mbps) Ethernet cabling
Category 3, Category 4, and Category 5 UTP cable, as well as EIA/TIA-
568 100-ohm STP cable, all qualify under traditional Ethernet cabling rules. The
maximum cable run between the DFE-670TXD and the supporting hub is 300 ft.
The cable must be straight (not a crossover cable) with an RJ-45 plug at each end.
3/15/2001
11:01 AM
A
B
Page 12

Advertisement

loading