Table of Contents
Advertisement
Troubleshooting
Symptom
Leads and connectors are not
Power doesn't
properly connected.
turn on.
The fuse is blown.
The unit doesn't
operate.
Noise and other factors are
causing the built-in
microprocessor to operate
incorrectly.
Playback is not
The disc is dirty.
possible.
The loaded disc is of a type this
unit cannot play.
No sound is
Cables are not connected
heard.
correctly.
The volume
level will not
rise.
There's no
The volume level is low.
sound.
There's audio
This unit is not firmly secured.
skipping.
The unit does
Battery power is low.
not operate
Some operations on certain
correctly even
discs are limited.
when the
appropriate
remote control
buttons are
pressed.
Cause
52
Correction
Confirm once more that all
connections are correct.
Rectify the problem that caused
the fuse to blow and then replace
it. Be very sure to install the
correct fuse with the same rate.
Turn the unit off and then on.
Clean disc.
Check what type the disc.
Connect the cables correctly.
Adjust the volume.
Secure this unit firmly.
Load new battery.
Check using another disc.
Advertisement
Table of Contents
