Download Table of Contents Print this page

Inserting A Disc; Removing A Disc; Emergency Eject - NEC DV-5500A User Manual

Internal dvd-rom reader

Advertisement

Table of Contents
14

Inserting a Disc

1. Press the Load/Eject button. The disc tray will be ejected.
2. Place the disc in the center of the tray with the label side facing up.
3. Press the Load/Eject button. The disc tray will be retracted.

Removing a Disc

1. Press the Load/Eject button. The disc tray will be ejected.
2. Remove the disc.
3. Press the Load/Eject button. The disc tray will be retracted.
WARNING:
Do not forcibly push the disc tray in by hand. Doing so may result in damage.
Note:
If an eject prohibit command has been received from the computer, the
disc tray will not be ejected even if the Load/Eject button is pressed.

Emergency Eject

The procedure described below can be used to remove a disc from the
DVD-ROM reader if the Load/Eject button is disabled by software or a
power failure occurs.
1. Turn off the power to the computer installed the DVD-ROM reader.
2. Insert a steel rod (about 1.3mm in diameter) into the emergency eject
EDV5500A.PM5
hole and push hard. The disc tray is ejected by about 10mm. Pull it all
the way open by hand.
A stiff paper clip may be used as a steel rod.
15
65mm
(AT LEAST 45mm IN LENGTH)
99.4.26, 5:32 PM

Advertisement

Table of Contents
loading

Table of Contents