Table of Contents
Advertisement
Figure 3. Secure Rails to Rack
5.
Align the 1U cable management tray (042-033-060) so that the UP arrow is pointed in the correct direction and the side of the
tray labeled FRONT is to the front of the rack.
Figure 4. Align the Cable Management Tray
6.
Slide the 1U cable management tray into the rails until it locks into place.
Mount the Expansion Enclosure
Install the rails in the rack, and mount the SC460 expansion enclosure on the rails.
Prerequisite
Required materials:
•
Screwdriver (034-000-193)
•
Six clip nuts (106-569-307)
•
Two M5 x 10 mm Phillips pan-head screws (106-002-452)
•
Two M5 x 16 mm Phillips pan-head screws (106-002-453)
•
Left and right expansion enclosure rack rails (100-569-001)
Steps
1.
Adjust the length of the expansion enclosure rack rails (100-569-001) to fit the rack.
2.
Attach the right rail to the back post of the rack.
6
Advertisement
Table of Contents
