Haier HWO60S11TPX1 User Manual page 5

The kitchen should be dry and have effective ventilation according to the
existing technical provisions.
Main lead behind the oven must be placed in such manner to avoid touching the
back panel of the oven because of the heat it develops during operation.
Remove any packaging materials(foils,artificial foam,nails,etc.)from the reach of
children,because they represent potential danger.Children may swallow small parts,
or suffocate with foils.
This is a built-in oven,which means that its back wall and one side wallcan be
placed next to a high piece of furniture or a wall.Coating or veneer used on fitted
furniture must be applied with a heat resistant adhesive(100℃),This prevents
surface deformation or detachment of the coating.If you are unsure of your
furniture's heat resistance,you should leave approximately 2cm of free space around
the oven.The wall behind the oven should be resistant to high temperatures.During
operation,its back side can warm up to around 50
Make an opening with the dimensions given in the diagram for the oven to be fitted.
The appliance must be earthed.
Insert the oven completely into the opening without allowing the four screws in the
places shown in the diagram to fall out.
℃
.
above the ambient temperature
Before attempting the connection,
check whether the voltage indicated
on the rating plate corresponds to
the actual mains voltage.
Mains lead should be minimum1.5m
long.
Earthing wire should be installed in
such manner to be the last one pulled
out in case the safety relief device of
the mains lead should fail.
Mains lead behind the oven must be
placed in such manner to avoid
touching the back panel of the oven
because of the heat it develops
during operation.
The cable of corroct size rating must
2
m
.
1.5m the grounding wire shall be
longer than the other wires.
The means for disconnection from
the supply mains having a contact
separation in all poles that provide
full disconnection under over voltage
category iii shall be provided in the
fixed wiring in accordance with the
wiring rules.
(by authorised electrician)
-
z z z z