Installation - Miele KM 3034 Operating And Installation Instructions

Preparing the worktop
 Make the worktop cut-out as shown
in the building-in diagram. Observe
the safety distances (see "Safety
distances").
 Seal the cut surfaces on wooden
worktops with a suitable sealant to
avoid swelling caused by moisture.
The sealant must be heat-resistant.
Make sure the sealant does not
come into contact with the top
surface of the worktop.
The seal underneath the cooktop will
hold it securely in the cut-out. Any gap
between the frame and worktop will
reduce with time.
Installing the cooktop
 Feed the mains connection cable
down through the cut-out.
 Place the cooktop unfastened in the
cut-out. When doing this, make sure
that the seal under the cooktop sits
flush with the worktop on all sides.
This is important to ensure an
effective seal all round.
Do not use any additional sealant
(e.g. silicone).
If the seal does not meet the worktop
correctly on the corners, the corner
radii (≤ R4) can be carefully scribed to
suit.
 Connect the cooktop to the mains
electricity supply.
 Connect the cooktop to the gas
supply (see "Gas connection").

Installation

47