Handlebar Switches - Yamaha BLASTER YFS200S Owner's Manual

w
1. Light switch "LIGHTS"
2. Engine stop switch "ENG. STOP"
1. Contacteur d'éclairage "LIGHTS"
2. Coupe-circuit du moteur "ENG. STOP"
1. Interruptor de luce "LIGHTS"
2. Interruptor de paro del motor "ENG. STOP"
q
EBU00053

Handlebar switches

EBU01158
Engine stop switch "ENG. STOP"
Make sure that the engine stop switch is in the
"RUN" position before starting the engine. The
engine stop switch controls ignition and can be
used at all times to stop the engine, especially in
an emergency. The engine will not start or run
when the engine stop switch is turned to "OFF".
EBU01286
Light switch "LIGHTS"
Set the switch to the "LO" position to switch on
the low beam and the taillight.
Set the switch to the "HI" position to switch on
the high beam and the taillight.
Set the switch to the "OFF" position to switch off
all the lights
NOTE:
The headlight and the taillight can be turned on
only when the engine is started.
4-9