Table of Contents
Advertisement
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
Temperature cannot be set. The ActionFreeze function
The temperature in the ap-
pliance is too low/too high.
8.2 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
Possible cause
The ActionFreeze function
is switched on.
The lid is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
is switched on.
The temperature regulator
is not set correctly.
The lid is not closed cor-
rectly.
The products' temperature
is too high.
Many products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid has been opened of-
ten.
The ActionFreeze function
is switched on.
Products to be frozen are
placed too closely to each
other.
model and serial number of your appliance
which can be found either on the
guarantee certificate or on the rating plate
located on the external right side of the
appliance.
ENGLISH
Solution
Refer to "ActionFreeze
function".
Refer to "Opening and clos-
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chap-
ter.
The compressor starts after
a period of time.
Refer to "ActionFreeze
function".
Set a higher/lower tempera-
ture.
Refer to "Opening and clos-
ing the lid".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if neces-
sary.
Refer to "ActionFreeze
function".
Make sure that there is cold
air circulation in the appli-
ance.
11
Advertisement
Table of Contents
