JVC LX-WX50 User Manual page 11

Installing/replacing the remote control battery
1. Pull out the battery holder, as illustrated. Push and hold the
locking arm whilst pulling out the battery holder.
2. Insert the new battery in the holder. Note the positive
polarity should face outward.
3. Push the holder into the remote control.
• Avoid leaving the remote control and battery in an excessive heat
or humid environment like the kitchen, bathroom, sauna,
sunroom or in a closed car.
• Replace only with the same or equivalent type recommended by
the battery manufacturer.
• Dispose of the used batteries according to the manufacturer's instructions and local environment
regulations for your region.
• Never throw the batteries into a fire. There may be danger of an explosion.
• If the batteries are drained or if you will not be using the remote control for an extended period of time,
remove the batteries to avoid damage to the remote control from possible battery leakage.
Remote control effective range
The remote control must be held at an angle within 30 degrees perpendicular to the projector's
IR remote control sensor(s) to function correctly. The distance between the remote control and
the sensor(s) should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor(s) on the
projector.
• Operating the projector from the front • Operating the projector from the top
Overview 11