Display Settings; Troubleshooting - Kenwood kdc-bt700dab Manual For Use And Installation

DISPLAY SETTINGS

Set the dimmer
Press and hold DISP (DIMMER) to turn on or off the
dimmer.
• If you have set [DIMMER TIME], it will be canceled once you
press and hold this button.
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [DISPLAY], then press
the knob.
3
Turn the volume knob to select an item (see the
following table), then press the knob.
4 3
Repeat step until the desired item is selected/
activated or follow the instructions stated on the
selected item.
5
Press and hold to exit.
To return to the previous setting item, press
DIMMER Dim the display illumination.
ON: Dimmer is turned on. ; OFF: Cancels.
DIMMER TIME: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then
press the knob.
2 Turn the volume knob to adjust the [OFF] time,
then press the knob.
(Default: [ON]: 18:00; [OFF]: 6:00)
BRIGHTNESS 0 — 31: Select your preferred brightness level for
display illumination.
TEXT SCROLL AUTO/ ONCE: Select whether to scroll the display
information automatically, or scroll only once. ;
OFF: Cancels.
20

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING THEN
PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the display
is incorrect.
The unit does not work at all.
DAB reception is poor.
"DAB ANT ERR"
.
"RELATED SERV FOUND"
Default: XX
• Radio reception is poor.
• Static noise while listening to the
radio.
Disc cannot be ejected.
Noise is generated.
Tracks do not play back as you
intended them to play.
"READING" keeps flashing.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals of the
speaker wires are insulated properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 23)
Reset the unit. ( 3)
Make sure [ON] is selected for [DAB ANT POWER]. ( 4)
Check the DAB antenna. If a passive antenna (without a
booster) is used, set [DAB ANT POWER] to [OFF]. ( 4)
• Press the volume knob to activate Soft-Link. ( 7)
• Press
to cancel.
Connect the antenna firmly.
Press and hold M to forcibly eject the disc. Be careful not
to drop the disc when it is ejected. If this does not solve the
problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are recorded.
Do not use too many hierarchical levels or folders.