SIGNALS DURING OVEN SETTINGS
ONE SIGNAL: Oven accepts the entry.
TWO SIGNALS: Oven does not accept the entry, check and try again.
SETTING THE CLOCK
Touch CLOCK pad.
1.
Use the number pads to enter the correct
2.
time.
Touch CLOCK pad again.
3.
NOTE:
·This is a 12 hour clock. When the oven is first
plugged in or when power resumes after a power
interruption, the display will show ENTER CLOCK
TIME. If you prefer to not have the clock displayed,
touch RESET.
SETTING THE KITCHEN TIMER
Touch KITCHEN TIMER.
1.
Enter the amount of time by touching the
2.
number pads.
Touch STOP/START.
3.
NOTE:
·Maximum time you can enter is 99 minutes and
99 seconds. Time countdown can be seen in
display by touching KITCHEN TIMER pad during
timing process.
·Touch KITCHEN TIMER and then RESET to
cancel TIMER during timing process.
SETTING A COOKING PROGRAM
A. One-stage Cooking
Use the number pads to set a cooking time.
1.
You can set a cooking time from one second to 99
minutes and 99 seconds.
If you want to set a power level other than
2.
100% power, touch POWER, then use the number
pads to enter the power level.
Touch STOP/START to start cooking.
3.
Use digits to set a cooking power level:
OPERATION INSTRUCTIONS
Number pad
1、0
9
8
7
6
5
4
3
2
1
0
B. Two-stage Cooking
Some recipes require different stages of
cooking at different temperatures.
SET STAGE 1:
1.
Follow steps 1 and 2 in "One-stage Cooking". DO
NOT TOUCH STOP/START
SET STAGE 2:
2.
Touch COOK TIME then enter proper cooking
time and (lower) power level. (Most 2-stage recipes
use lower power for second stage.)
Touch STOP/START.
3.
NOTE:
·After stage 1 time has elapsed, one signal
sounds, signaling the beginning of stage 2.
·After total time has elapsed, signals sound and
END appears in display. Touch any pad or open
oven door to clear END before starting another
cooking function.
SPEED DEFROST
The longest defrosting time is 99 minutes and 99
seconds.
9
Cooking power
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%
Need help?
Do you have a question about the EM-S355AW/AS and is the answer not in the manual?