Haier HLC15T Service Manual page 15

Hide thumbs Also See for HLC15T:

Table of Contents

Choose Your Connection

There are several ways to connect your television, depending on the components you want to connect

and the quality of the signal you want to achieve. The following are examples of some different ways

to connect your TV with different input sources. Choose the connection which is best for you.

VCR connection

S- Video

CV BS

S- Video/ CVB S

Audi o In

picture quality is improved; compared to connecting a regular VCR to the Video input.

2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner`s manual.)

To avoid picture noise (interference), leave an adequate distance

between the VCR and TV

INP UT

AV OUT

Connection Option 1

Set VCR output switch to channel 3 or 4 and

then tune the TV to the same channel number.

Connection Option 2

1. Connect the audio and video cables from the

VCR's output jacks to the TV input jacks, as

shown in the figure.

When connecting the TV to VCR, match the

jack colors (Video = yellow, Audio Left = white,and Audio Right = red).If

you connect an S-VIDEO output from VCR tothe S-VIDEO input, the

■ To improve the picture quality in a poor signal area,

please purchase a signal amplifier and install properly.

■ If the antenna needs to be split for two TV`s, install a "2-

Way Signal Splitter" in the connections.

■ If the antenna is not installed properly, contact your dealer

for assistance.

Table of Contents